Garden Set-up

Step 1 – Assemble Materials

You will need all materials in your stand box, as well as your pair of strip light hangers and your Phillips head screwdriver.

The materials inside of your stand box will be:

• • 2 -18” support bars
  • 2 – bases for support bars
  • 2 – light grips
  • 2 – end caps for support bars
  • 4 – height adjustment O-rings 
  • 2 – wing nuts (not present in all stand set-ups)

Step 2 – Place bases upright and insert the support bars

Ensure that support bars are sitting firmly in the bases.

Step 3 – Install one O-ring on each support bar

The O-rings are used to adjust the height of your lights by rolling them up or down the support bar. Use caution when stretching the rings over the support bars as the metal edges can be sharp.

Step 4. Install one light strip hanger onto each light grip.

Each light strip hanger will come with a stabilizer screw in the center of each hanger. Set the screws aside momentarily. Identify the square-raised middle section of your strip light hangers. This will be where you connect each light grip, by snapping it into place. After snapping one light strip hanger onto each light grip, secure the light strip hanger with your stabilization screws. Insert a screw into the bottom center hole of each light strip hanger. Screw into place using your Phillips head screwdriver.

Step 5. Install one light grip with attached light strip hanger, onto each support bar.

Ensure that your light grip is installed on the support bar so that the attached light strip hanger is on the same side as the flat edge of the base.

Step 6. Install one end cap onto each support bar.

Step 1

Remove the light fixtures from the packaging and inspect any for damage

Step 2

Remove light bulbs from fixtures

Step 3

Remove the protective film from the underside of the reflector on each light

Step 4

Install fixtures onto light strip hangers

Step 5

Re-install light bulbs into fixtures

Step 6

Install linking cord between lights and power cord